3/18/2023 0 Comments Test tone network kitSmartTone™ feature gives positive identification of cables in bundles when using an IntelliTone or an analog probe. Generates four tones compatible with typical analog probes. Supports toning and cable mapping with a Fluke Networks digital IntelliTone™ probe. MicroScanner PoE: Detects the advertised speed of 802.3 Ethernet ports with speeds of 10 Mbps, 100 Mbps, 1 Gbps, 2.5 Gbps, 5 Gbps, and 10 Gbps. The powerful Trend tone generator transmits strong tone signals via RJ45 port to test up to 12 miles of copper cabling with two different patterns. MicroScanner 2: Detects the advertised speed of 802.3 Ethernet ports with speeds of 10 Mbps, 100 Mbps, and 1 Gbps. Some of them can even be used during hearing therapies. The wiremap is drawn with proportional length to visually indicate the approximate location of faults. These test tones will help you testing your audio equipment, loudspeakers, headphones, and room acoustics. Can determine actual NVP with known length of cable.ĭetects single-wire faults, shorts, miswires, split pairs, and up to seven far-end adapter IDs. Klein VDV Commander Network and Cable Test Kit with Tone Probe Locate, test and measure coaxial, data RJ45 and telephone RJ11 cables Identify wiring. NVP uncertainty is an additional error.Ĭalibration: User-settable NVP for twisted pair and coax (MicroScanner 2). Typical accuracy: ± 4% or 0.6 m (2 ft) whichever is greater. MicroScanner 2: Solicits and detects the presence of 802.3af compatible PoE (Power over Ethernet) devices MicroScanner PoE: Solicits and detects the presence of 802.3af, at, bt, and UPOE (Cisco’s Universal Power over Ethernet) compatible PoE devicesĬoaxial (MicroScanner 2): 75 Ω, 50 Ω, 93 Ω Generates Intellitone™ and normal analog toning signals MicroScanner PoE also shows HIGH Ω when the resistance of the cable is more than 12.5 Ω. Measures length, verifies wiremap, identifies remote ID locators, and detects Ethernet ports. Other compatible battery types: 2 AA photo lithium, NIMH, NICADĭimensions and weight (with batteries installed and wiremap adapter attached)ģ in x 6.4in x 1.4 in (7.6 cm x 16.3 cm x 3.6 cm) MicroScanner 2: 10.6 oz (300 g) MicroScanner PoE: 10.6 oz (300 g) MicroScanner 2: F-connector for coaxial cable.īattery type: 2 AA (NEDA 15A, IEC LR6) alkaline batteries Shielded 8-pin modular jack accepts 8-pin modular (RJ45) and 4-pin modular (RJ11) plugs. Test Modes: Cable test: Tone: Generates Intellitone and normal analog toning signals: PoE: MicroScanner 2: Solicits and detects the presence of 802.3af compatible PoE (Power over Ethernet) devices MicroScanner PoE: Solicits and detects the presence of 802. Operating relative humidity (% RH without condensation)ġ m drop test with and without wiremap adapter attached
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |